Digital Monitoring Products 1912XR Instalační příručka stáhnout pdf (Strana 29)

Digital Monitoring Products, Inc.

1912XR Programming

Page 23

CLS CHK NO

ACCOUNT NO: 12345

12.7 CLOSING CHECK - Enter YES to enable the panel to verify that all areas in this

partition have been armed after temporary or permanent schedules have expired.

If the Closing Check finds any areas disarmed past the scheduled time, the

keypad selected to display System Trouble Status emits a steady beep and

displays CLOSING TIME!.

If you select Area Schedules in section 12.10, the appropriate area name is

displayed followed by - LATE. The keypad's steady beep is silenced by pressing

any top row SELECT key. If the system is not armed or a temporary schedule not

extended within ten minutes, a No Closing Report is sent to the SCS-1 Receiver.

If the area has been disarmed outside of any permanent or temporary schedule,

the closing check sequence occurs one hour after the area was disarmed.

12.8 CLOSING CODE - When YES is selected, a code number is required for system

arming. If NO is selected, a code number is not required for system arming.

12.9 ANY BYPASS - When YES is selected, loops can be bypassed without a code

number during the arming sequence. A code number is always required to use

the Bypass Loops option from the menu.

12.10 AREA SCHEDULES - Enter YES to allow each area in this partition to set its own

permanent and temporary, or primary and secondary user disarming schedules.

Enter NO to provide 1 set of disarming schedules for each partition.

12.11 PRIMARY/SECONDARY SCHEDULES - Enter YES to provide primary and

secondary schedules for this partition or each area within this partition depending

on the Area Schedules option selected in section 12.10. Enter NO to use

permanent and temporary schedules.

12.12 AREA NUMBER - Enter the number of the area in this partition you are

programming. In an area system, partition 1 can have up to eight areas.

Partitions 2 to 4 can each have up to 4 areas. After entering the area number,

press COMMAND to enter the area name.

12.13 AREA NAME - The area name can be up to 10 alphanumeric characters.

Only

those areas having loops assigned to them are given names.

All others are

marked unused. For instructions on entering alphanumeric characters, refer to

section 1.7.

To mark an area unused, delete the old name by pressing a top row SELECT

key, then press the COMMAND key. The programmer automatically programs

the name as *UNUSED*. If you have already cleared Area Information during

Initialization, all areas will be marked * UNUSED *. See section 2.6.

12.14 ACCOUNT NUMBER - Enter the account number to be sent to the SCS-1

Receiver for this area. If the panel communicates in multiplex (MPX), you must

choose account numbers in the multiplex range. See section 3.4 for additional

information on communication types.

CLS CODE NO

ANY BYPS NO

AREA SCH NO

PRI/SEC NO

NAME: –

AREA NO: –

12-AREA INFORMATION

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products 1912XR Instalační příručka Strana 29

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products 1912XR