Digital Monitoring Products Graphic Touchscreen Uživatelská příručka stáhnout pdf (Strana 19)

Arming and Disarming XT30/XT50 User Guide 15

Disarming During an Alarm

1. While the alarm bell or siren sounds, enter your user code to

silence the alarm. The keypad tone silences as soon as the

rstkeyispressed.

For a burglary alarm, the keypad displays

IS THIS A FALSE ALARM? NO YES or CANCEL VERIFY.

This allows you to investigate the alarm prior to disarming the

system. This display remains on the keypad until a selection

is made, the Back Arrow is pressed, or the internal system

bell cutoff timer expires.

2. If a valid alarm has not occurred, select YES or CANCEL to

disarm the system and cancel the alarm.

ThekeypadnextdisplaysALLSYSTEMOFFtoconrmthesystem

is disarmed.

If the alarm is valid, select NO or VERIFY to send a verify message

to the Central Station. The system will remain armed.

All/Perimeter System Arming

Area Assignment: Your security system is divided into two separate

areas. Motion detectors, inside doors, and other interior protection

devices are assigned to the Interior area while windows and exterior

doors are assigned to the Perimeter area.

Perimeter or All: When arming an All/Perimeter system, the keypad

displays PERIM ALL. If you select ALL, you arm both the Perimeter

and the Interior of the system. You want to arm both of these areas

when leaving with nobody left inside. Selecting PERIM arms only

the Perimeter of the system. Perimeter arming is for when you are

staying inside but want the comfort of knowing the exterior doors

and windows are armed. Perimeter arming allows you to move freely

about inside without setting off any interior alarms.

Disarming an Area System

1. Press the COMMAND key until ARM DISARM displays. During

entry delay this process starts at step 3 below.

2. Select DISARM to disarm areas.

3. The keypad displays ENTER CODE: . Enter your user code and

press COMMAND. The keypad displays ALL? NO YES.

4. Select YES to disarm all areas authorized for your user code.

4a. Select NO to disarm only certain areas individually. The

keypad then displays the name of each area authorized for

your code followed by the NO YES display.

4b. Select YES to disarm the area displayed.

4c. Select NO to not disarm and to display the next area.

Note: You can also just press the area numbers you want to disarm

while at the ALL? NO YES display. This changes the display to

AREAS: . The area numbers you select appear in the display.

For example: AREAS: 2 4.

To remove an area number from the display, press its

corresponding number on the keypad. Press COMMAND when

done.

5. After all areas have displayed, any alarms or communication

problems that occurred during the armed period are shown.

6. If all areas are disarmed, the keypad displays

ALL SYSTEM OFF.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 66 67

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products Graphic Touchscreen Uživatelská příručka Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products Graphic Touchscreen