Digital Monitoring Products Canadian XR100 Instalační příručka stáhnout pdf (Strana 15)

Digital Monitoring Products XR100 Series Installation Guide

INTRODUCTION

XR100 Series Installation Guide Digital Monitoring Products

INSTALLATION

Installation

4.1 Mounting the Enclosure

The metal enclosure for the XR100 Series must be mounted in a secure, dry place to protect the panel from damage

due to tampering or the elements. It is not necessary to remove the XR100 Series PCB when installing the enclosure.

Figure 2 shows the mounting hole locations for both the Model 350/350A Enclosures.

Note: When using the XR100 Series panel for UL Listed applications, use the Model 350, 349, 341, 342, or 352S

enclosure for standby batteries. When using the 352S in UL listed applications, the enclosure must be surface

mounted on the wall.









































                          





                      

 

 

































 



































Figure 2: XR100 Series in Model 350 or 350A Enclosure

4.2 Mounting Keypads and Zone Expansion Modules

DMP LCD keypads have removable covers that allow you to easily mount the keypad to a wall or other at surface

using the screw holes on each corner of the base. Before mounting the base, connect the keypad wire harness leads

to the keypad cable from the panel and to any device wiring run to that location. Then attach the harness to the

pin connector on the PC board, mount the base, and install the keypad cover making sure all of the keys extend

through their respective holes.

For mounting keypads on solid walls, or for applications where conduit is required, use the Model 695 1-1/2” deep or

the Model 696 1/2” deep backboxes.

The DMP 711, 712-8, 714, 715, 716, and 717 modules are each contained in molded plastic housings with removable

covers. The base provides you with mounting holes for installing the unit to a wall, switch plate, or other surface.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products Canadian XR100 Instalační příručka Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products Canadian XR100