Digital Monitoring Products XR550 Instalační příručka stáhnout pdf (Strana 23)

XR150/XR350/XR550 Series Installation Guide Digital Monitoring Products

InstallatIon

If the XR150/XR350/XR550 Series causes harm to the telephone network, the telephone company will notify you

in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the

telephone company will notify the customer as soon as possible. Also, you will be advised of your right to le a

complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect

the operation of the equipment. If this happens the telephone company will provide advance notice in order for you

to make necessary modications to maintain uninterrupted service.

If trouble is experienced with the Model XR150/XR350/XR550 Series, for repair or warranty information, please

contact DMP at the address and telephone number listed on the back of this document. If the equipment is causing

harm to the telephone network, the telephone company may request that you disconnect the equipment until the

problem is resolved. If your premises have specially wired alarm equipment connected to the telephone line, ensure

the installation of the panel does not disable your alarm equipment. If you have questions about what will disable

alarm equipment, consult your telephone company or a qualied installer.

Caution: To ensure proper operation, this equipment must be installed according to the installation instructions in

this manual. To verify that the equipment is operating properly and can successfully report an alarm, this equipment

must be tested immediately after installation, and periodically thereafter, according to the test instructions in this

document and the XR150/XR350/XR550 Series Programming Guide (LT-1232). Additionally, verication of Line Seize

capability should be made immediately after installation, and periodically thereafter, in order to ensure that this

equipment can initiate a call even when other equipment (telephone, answering system, computer modem, etc.)

connected to the same line is in use.

Reset and Tamper Headers

18.1 J16 Reset Header

The reset header is located to the left of the J7 Expansion Header on the right

side of the circuit board and is used to reset the XR150/XR350/XR550 Series

microprocessor. To reset the panel when rst installing the system, install the

reset jumper before applying power to the panel. After connecting the AC and

battery, remove the reset jumper.

To reset the panel while the system is operational, for example, prior to

reprogramming, install the reset jumper without powering down the system.

Remove the reset jumper after one or two seconds.

After resetting the panel, begin programming within 30 minutes If you wait

longer than 30 minutes, you must reset the panel again.

18.2 J4 Tamper Header

The J4 header is for use with the optional DMP 306 Tamper Harness. The

harness connects to one or more tamper switches mounted inside the panel

enclosure to supervise against unauthorized enclosure opening or removal.

Refer to the wiring diagram on the enclosure door for correct tamper switch

wiring.

How the Tamper Works

If the enclosure is opened or removed while one or more of the system areas

are armed, a panel tamper alarm is indicated. If all areas are disarmed, a

panel tamper trouble is indicated.

Figure 12: XR550 Series Panel

Showing the Reset Jumper

Momentarily place the Reset

jumper over both of the J16

pins to reset the panel.

1 2 ... 18 19 20 21 22 23 24 25 26

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products XR550 Instalační příručka Strana 23

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products XR550