Digital Monitoring Products XR550 Instalační příručka stáhnout pdf (Strana 5)

XR150/XR350/XR550 Series Installation Guide Digital Monitoring Products

IntroductIon

Product Specications Summary

1.1 Power Supply

Transformer Input: Model 327, plug-in — Primary input: 120 Vac, 60 Hz, Secondary output: 16.5 Vac 50 VA

Model 322/323, wire-in — Primary input: 120 Vac, 60 Hz, Secondary output: 16 Vac 56 VA

Model 324/324P, wire-in — Primary input: 120 Vac, 60 Hz, Secondary output: 16 Vac 100 VA

Standby Battery: 12 Vdc, 1.0 Amps Max. charging current

Models 364, 365, 366, 368, or 369

Replace every 3 to 5 years

Auxiliary *: 12 Vdc output at 1.5 Amp Max

12 Vdc output at 325mA used with two Model 364 batteries in the Model 341 enclosure

Bell Output *: 12 Vdc at 1.5 Amp Max

All circuits are inherent Power Limited except the red battery wire and AC terminal.

* See section 5.3 J12 3-Pin Header for Transformer Types for panel output 2 Amp or 3 Amp current limitations.

1.2 Communication

• Built-in network communication to DMP Model SCS-1R Receivers (Panels with Network/Encryption only)

• Built-in 128-bit or 256-bit encrypted communication to DMP Model SCS-1R Receivers (XR550 with

Encryption only)

• Built-in Contact ID communication to DMP Model SCS-1R Receivers

• Optional 893A Dual Phone Line Module with phone line supervision

• Can operate as a local panel

Note: 256-bit encrypted messages to SCS-1R receiver only communicate when using SCS-104 Receiver Line Cards

with Version 102 or higher software.

1.3 Panel Zones

• Eight 1k Ohm EOL burglary zones (zones 1 to 8)

• Two 3.3k Ohm EOL powered zone with reset (zones 9 and 10)

1.4 Keypad Bus

You can connect up to a total of 16 of the following supervised keypads and expansion modules to keypad bus:

• Alphanumeric keypads • Four, Eight- and/or single-zone expansion modules

• Single-zone detectors • Access control modules

• Wireless Keypads (maximum of 4)

1.5 LX500-LX900 Bus™

You can connect the following devices to the LX-Bus™ connections provided on the panel. See Accessory Devices

section 3.3.

• Four, eight, sixteen- and/or single-zone expansion modules • Single-zone detectors

• Relay output expansion modules

• Graphic annunciator modules

1.6 Outputs

The XR150/XR350/XR550 Series provide two Single Pole, Double Throw (SPDT) relay outputs which require the

installation of two Model 305 relays, each rated 1 Amp at 30 Vdc resistive (power limited sources only). A Model 431

Output Harness is required to use these outputs.

The XR150/XR350/XR550 Series panels also provide four open collector outputs rated for 50mA each. The open

collector outputs provide ground connection for a positive voltage source. A Model 300 Output Harness is required to

use these outputs.

1.7 Enclosure Specications

The XR150/XR350/XR550 Series panels are shipped in an enclosure with a transformer, End-of-Line resistors, battery

leads, user’s guide, and programming sheets.

Enclosure

Model

Size Color(s) Construction (Cold Rolled

Steel)

350 17.5”W x 13.5”H x 3.5”D Gray (G) or Red (R) 18-Gauge

350A 17.5”W x 13.5”H x 3.75”D Gray (G) 18-Gauge with 16-Gauge door

341 13.22”W x 7.0”H x 3.5”D Gray (G) 20-Gauge

349 12.5”W x 11.5”H x 3.5”D Gray (G) 20-Gauge

352X 14.5”W x 32.0”H x 4.0”D Gray (G) 16-Gauge

1 2 3 4 5 6 7 8 9 10 ... 25 26

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products XR550 Instalační příručka Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products XR550