Digital Monitoring Products Canadain XR500 Uživatelská příručka stáhnout pdf (Strana 25)

System Link User’s Guide 15

Zone#

: This field determines how many digits may be assigned to report a zone number.

This number should correlate with the number of digits of the zones that report to the

panel. For example, the XR200 panel has zones 1-299. So you would want to set this to 3

to allow all 299 zones to report. If you are using an SCS-1 or SCS-1R Receiver this number

must match the zone number programmed in the Host/Net setup programming on the

receiver.

User#

: Select the number of digits used to report a user number. Select 3 to allow 999

users. If you are using an SCS-1 or SCS-1R Receiver, this number must match the User

number programmed in the Host/Net setup programming on the receiver.

Default Receiver:

(Must have a module to Use) Refer to the module User’s Guide for

more information.

Modem Tab

Use the Modem tab to configure System Link when

connecting to a DMP 462FM 9600 Baud Modem

installed on a panel or when connecting to an

XR500 Series or XR100 Series for programming at

2400 baud through the panel dialer. This allows

you to connect to the panel using a standard

computer modem.

Communication Options

COM Port

: Select the COM port that is connected

to your modem.

Baud Rate

: Set the baud rate for System Link to communicate with the computer modem.

Default setting is 9600.

Flow Control

: Select the flow control option recommended by your modem manufacturer.

The default setting is Hardware. If the modem does not operate correctly with the default

Hardware setting, select XON/XOFF, also known as software flow control. If neither setting

operates correctly, select None. For more information see your modem documentation.

Tone Dial

: Leave this box checked unless the phone line connected to the modem on your

System Link computer is connected to a phone line that cannot process touch-tone dialing.

General Options

Dial Timeout:

Enter the length of time System Link will wait for the XR500 Series, XR100

Series, or 462FM to pick up.

Modem Initialization String:

If an initialization string is required for the modem

communicating to the panel, enter the setup string here. The string can be up to 32

characters long.

Special Initialization String:

The special initialization string required to ensure the

modem communicates consistently at a slower baud rate is entered here. The string can

be up to 32 characters long.

Note: Only one initialization string can be used. Select the correct one for your operation.

See Panel Information on page 28.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products Canadain XR500 Uživatelská příručka Strana 25

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products Canadain XR500