Digital Monitoring Products Canadian XR100 Instalační příručka stáhnout pdf (Strana 14)

Digital Monitoring Products XR100 Series Canadian Installation Guide

InstallatIon

Primary Power Supply

5.1 AC Terminals 1 and 2

Connectthetransformerwirestoterminals1and2onthepanel.Usenomorethan70ft.of16gaugeor40ft.of18gauge

wire between the transformer and the XR100 Series.

Always ground the panel before applying power to any devices: The XR100 Series must be properly

grounded before connecting any devices or applying power to the panel. Proper grounding protects against

Electrostatic Discharge (ESD) that can damage system components. See Earth ground section 6.2.

5.2 Transformer Types

Use Model 327-CAN (16.5 Vac 50 VA) plug-in or Model FTA7516 from ATC Frost.

The transformer must be connected to an unswitched 120 Vac 60 Hz electrical outlet with at least .87A of

available current. Never share the transformer output with any other equipment.

5.3 J12 3-Pin Header for Transformer Types

Place the jumper on the left two pins for a Maximum 2 Amp (Bell=1 Amp; Aux=1 Amp) when using the Model 327-CAN plug-

in transformer (default).

Use an ATC Frost FTA7516 transformer and place the jumper on the right two pins for a Maximum, 3 Amps (Bell=1.5 Amp;

Aux=1.5 Amp).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Žádné komentáře

Digital Monitoring Products Canadian XR100 Instalační příručka Strana 14