Digital Monitoring Products Canadian XR100 Instalační příručka stáhnout pdf (Strana 7)

XR100 Series Canadian Installation Guide Digital Monitoring Products

IntroductIon

Product Specications

1.1 Power Supply

Transformer Input: Model 327-CAN, plug-in — Primary input: 120 Vac, 60 Hz, Secondary output: 16.5 Vac 50 VA

Model FTA7516 ATC Frost from Standex Electronics — Primary input: 120 Vac, 60 Hz,

Secondary output: 16 Vac 75 VA

Standby Battery: 12 Vdc, 1.0 Amps Max. charging current

Models 365, 366, 368, or 369

Replace every 3 to 5 years

Auxiliary: 12 Vdc output at 1.0 Amp Max using Model 327-CAN

Bell Output: 12 Vdc at 1.0 Amp Max using Model 327-CAN

Auxiliary: 12 Vdc output at 1.5 Amp Max using Model FTA7516

Bell Output: 12 Vdc at 1.5 Amp Max using Model FTA7516

All circuits are inherent Power Limited except the red battery wire and AC terminal.

1.2 Communication

• Built-in network communication to DMP Model SCS-1R or SCS-VR Receivers (XR100N only)

• Built-in encrypted communication to DMP Model SCS-1R Receivers

• Built-in Contact ID communication to DMP Model SCS-1R Receivers

• Optional cellular communication to DMP Model SCS-1R or SCS-VR Receivers

• Can operate as a local panel

1.3 Panel Zones

Eight 1k Ohm EOL burglary zones (zones 1 to 8)

Two 3.3k Ohm EOL powered zone with reset (zones 9 and 10)

1.4 Keypad Bus

You can connect up to a total of eight of the following supervised keypads and expansion modules to the keypad bus:

• Alphanumerickeypads • Four-and/orsingle-zoneexpansionmodules

• Single-zonedetectors • Accesscontrolmodules

• WirelessKeypads(maximumof4)

1.5 LX-Bus™

YoucanconnectthefollowingdevicestotheLX-Bus™providedonthepanelorbytheDMP481,462Nand464-263H

InterfaceCardsuptothemaximumnumberofLX-Bus™addresses.SeeAccessoryDevicesinsection3.4.

• Sixteen-,eight-,four-and/orsingle-zoneexpansionmodules • Graphicannunciatormodules

• Model521LXor521LXTSmokeDetectorswithCleanMe  • Relayoutputexpansionmodules

• Model2W-BLXor2WT-BLXSmokeDetectors

1.6 Outputs

The XR100 Series provide two Single Pole, Double Throw (SPDT) relay outputs which require the installation of two Model

305relays,eachrated1Ampat30Vdcresistive(powerlimitedsourcesonly).AModel431OutputHarnessisrequiredto

use these outputs.

The XR100 Series also provide four open collector outputs rated for 50mA each. The open collector outputs provide ground

connection for a positive voltage source. A Model 300 Output Harness is required to use these outputs.

1.7 Enclosure Specications

The XR100 Series are shipped in an enclosure with a transformer, End-of-Line resistors, battery leads, user’s guide, and

programming sheets.

Enclosure

Model

Size Color(s) Construction (Cold Rolled Steel)

350 17.5”W x 13.5”H x 3.5”D Gray (G) or Red (R) 18-Gauge

350A 17.5”W x 13.5”H x 3.75”D Gray (G) 18-Gauge with 16-Gauge door

341 12.45”W x 6.55”H x 3.15”D Gray (G) 20-Gauge

Panel Features

2.1 Description

TheDMPXR100SeriesCanadianpanelisaversatile12Vdc,combinedaccesscontrol,burglary,andrecommunicator

panel with battery backup. The XR100 Series provides eight on-board burglary zones and two on-board 12 Vdc Class B

powered zones. The powered zones have a reset capability to provide for 2-wire smoke detectors, relays, or other latching

devices. The XR100 Series can communicate to DMP SCS-1R Receivers using digital dialer, cellular, network, or Contact ID

communication.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products Canadian XR100 Instalační příručka Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products Canadian XR100