Digital Monitoring Products XTL Series Instalační příručka stáhnout pdf (Strana 11)

Digital Monitoring Products XTL/XTLC Programming Guide

INTRODUCTION

1.9 Entering Non-Alpha Characters

To enter a space in an alpha entry, press the 9 digit key followed by the third Select key. The three characters

on the 9 digit key are Y, Z, and space. You can also enter the following characters: – (dash), . (period), *

(asterisk), and # (pound sign) using the 0 (zero) key and the four Select keys from left to right. For example, to

enter a – (dash), press the 0 (zero) key and then the left Select key. A dash now appears in the keypad display.

The table below shows the character locations for DMP keypads.

Key Number Select Key 1 Select Key 2 Select Key 3 Select Key 4

1 A B C (

2 D E F )

3 G H I !

4 J K L ?

5 M N O /

6 P

R &

7 S T U @

8 V W X ,

9 Y Z space _

0 - . * #

1.10 Keypad Displays Current Programming

Each programming option displayed at the keypad shows the currently selected option in the panel memory.

These options are either shown as a number, a blank, or a NO or YES. To change a number or blank to a new

number, press any top row Select key. The current option is replaced with a dash. Press the number(s) on the

keypad you want to enter as the new number for that option. It is not necessary to enter numbers with leading

zeros. The panel automatically right justies the number when you press the COMMAND key.

To change a programming option that requires a NO or YES response, press the Select key for the response not

selected. See Figure 3.

For example, if the current option is selected as YES and you want to change it to NO, press the third top row

Select key. The display changes to NO. Press the COMMAND key to display the next option.

THEN

Press the third top row

Select key.

The keypad displays the new

selection. Press CMD to advance.

YESBELL TST

NOBELL TST

Figure 3: Changing the Current Programming Option

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 48 49

Žádné komentáře

Digital Monitoring Products XTL Series Instalační příručka Strana 11