Digital Monitoring Products XT50 Instalační příručka stáhnout pdf (Strana 41)

Digital Monitoring Products XT Series Programming Guide

ZONE INFORMATION

14.10.11 Output Action

This option allows you to dene the output action (STD, PLS, MOM, TGL, OFF) for the

selected output number. The default is Steady.

STD (Steady) - The output is turned on and remains on.

PLS (Pulse) - The output alternates one second on and one second off.

MOM (Momentary) - The output is turned on only once for one second.

TGL (Toggle) - The output alternates between the on state and off state. Each button

press toggles the output state.

OFF (Off) - The output is turned off. If programmed, the output was turned on by some

other means such as another button press, a zone action, or a schedule.

Note: When the output is assigned to PN/PN2 or EM/EM2 button action and is turned

on, the output turns off when any area is disarmed.

When the output action is steady, pulse or toggle and the output is turned on, the

output remains on until:

— the output cutoff time expires

— the output is reset from the keypad menu

— toggled off

Note: All wireless programming is stored in the XT30 or XT50 panel. When using the XT30, the 1100D,

1100DI, or 1100DH Wireless Receiver obtains the necessary programming information from the panel each

time the receiver powers up, when the programmer STOP routine is selected or the panel is reset. The

receiver memory refresh takes up to 45 seconds to complete depending on the number of wireless zones

programmed and the Red LED remains on during this time. Normal receiver operation is inhibited during

the memory refresh period.

14.11 Alarm Action

The Alarm Action section allows you to change or conrm the default alarm

characteristics of a zone type.

If you selected the non-24-hour zone type Blank, Night, Day, Exit, Auxiliary 1, or

Auxiliary 2, the Alarm Action programing begins with Disarmed Open.

If you selected the 24-hour zone type Fire, Panic, Emergency, or Supervisory, the Alarm

Action programming begins with Armed Open.

The Fire Verify zone type functions the same as Fire Type, with the following exceptions:

When a Fire Verify zone is placed into shorted condition, the panel performs a Sensor

Reset and does not send a report. If any Fire Verify or Fire zone initiates an alarm within

120 seconds after the reset, an alarm is indicated. If an alarm is initiated after 120

seconds, the cycle is repeated. If no other Fire Verify or Fire zone is alarmed within 120

seconds, a zone fault report is sent to the receiver.

14.12 Disarmed Open

Denes the action taken by the panel when the zone is opened while the area is

disarmed. There are three actions to dene:

• Message to Transmit

• Output/Favorite Number

• Output Action

You must also make these selections for the Disarmed Short, Armed Open, and Armed

Short zone conditions. Press the COMMAND key to continue.

ACTION:

STD PLS MOM TGL

OFF

ALARM ACTION . . .

DISARMED OPEN

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 54 55

Komentáře k této Příručce

Žádné komentáře

Digital Monitoring Products XT50 Instalační příručka Strana 41

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Digital Monitoring Products XT50