
Digital Monitoring Products XT Series Programming Guide
38
Stop
15.1 Stop
At the STOP option, pressing any Select key allows you to exit the Programmer function
of the panel. When selected, the panel performs an internal reset and exits the
programmer.
The STOP routine causes the following conditions to occur:
• All 1100 Series DMP Wireless transmitters are reset to NORMAL
• The panel Status List is cleared
During the reset, all keypad displays are momentarily blank for two seconds. After the
reset, the programming function terminates and the keypads return to the status list
display.
The STOP option does not disarm the system. Any new areas or zones that were added
during programming are not armed until the system is disarmed and armed again.
SET LOCKOUT CODE
Set Lockout Code
16.1 Set Lockout Code
Pressing COMMAND at the Stop option displays SET LOCKOUT CODE. This feature allows
you to program a special code that will then be required to gain access to the panel’s
internal Programmer through the keypad.
Changing the Lockout Code
You can change this code at any time to any combination of numbers from 1 to 5 digits
long (1 to 65535). Do not use leading zeros for the lockout code.
1. Press any Select key. The display changes to ENTER CODE: - .
2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press
COMMAND.
3. Enter the new Lockout Code again. Press COMMAND. The keypad display changes to
CODE CHANGED.
Once you have changed the code, it is important that you write it down and store it in a
safe place. Lost lockout codes require the panel to be sent back into DMP for repair. You
may cancel a Lockout Code by entering 00000 at the Set Lockout Code command option.
Lockout Code restriction:
Do not set a Lockout Code higher than 65535.
STOP
SET LOCKOUT CODE
STOP
Komentáře k této Příručce