Digital Monitoring Products Canadian XR100 Manuál s instrukcemi stáhnout pdf (Strana 65)

XR100 Series Programming Guide Digital Monitoring Products

Stop

19.1

STOP

Stop

Save Programming

WHEN ANY PANEL PROGRAMMING IS CHANGED, THE STOP ROUTINE MUST BE

RUN AND ‘SAVING PROGRAM’ MUST DISPLAY ON THE KEYPAD IN ORDER TO SAVE

THE PROGRAMMING CHANGES.

At the STOP option, pressing any Select key allows you to exit the Programmer

function of the panel. When selected, the panel performs an internal reset and

exits the programmer.

The STOP routine causes the following conditions to occur:

•All1100SeriesDMPWirelesstransmittersareresettoNORMAL

•ThepanelStatusListiscleared

During the reset, all keypad displays are momentarily blank for two seconds. After

the reset, the programming function terminates and the keypads return to the

status list display.

The STOP option does not disarm the system. Any new areas or zones that were

added during programming are not armed until the system is disarmed and armed

again.

Power Up

For60secondsafterpowerupontheXR100Seriespanel,anyzonetransitionsare

notrecognized.Normalzoneprocessingresumesattheendofthe60seconds.

Set Lockout Code

20.1

SET LOCKOUT CODE

Set Lockout Code

PressingCOMMANDattheSTOPoptiondisplaysSETLOCKOUTCODE.Thisallows

you to program a code that is then required to gain access to the panel internal

Programmer through the keypad. You can change this code at any time to any

combinationofnumbersfromthreetovedigitslong.Youdonotneedtoenter

leading zeros when using the lockout code. Initializing the panel does not clear a

LockoutCode.LockoutCodescanbechangedthroughRemoteLink.

Once you have changed the code, it is important to write it down somewhere

andstoreitinasafeplace.LostLockoutCodesrequirethepaneltobesentback

toDMPforrepair.YoumaycancelaLockoutCodebyentering00000attheSet

LockoutCodecommand.

Lockout Code restriction

DonotsetaLockoutCodehigherthan65535.

set lockout coDe

stop

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 77 78

Žádné komentáře

Digital Monitoring Products Canadian XR100 Manuál s instrukcemi Strana 65